AB Soft MS6 Instrukcja Użytkownika

Opal Pro to Mod TCP Page 1 Opal Pro MS6 SERIES AB Ethernet IP Interface Users Manual Revision 1.00

Opal Pro to Mod TCP Page 10 I/O Configuration The Opal Pro supports 4 input words and 51 output words. Their description is as follows: Input Word

Opal Pro to Mod TCP Page 11 Output Words (Polled) AB Ethernet IP Name Description Bit 0 – Ready to Run (drive is enable and has 3 phase power) Bit

Opal Pro to Mod TCP Page 12 Relay Status Status of the Relay Outputs Bit 0 – Running Bit 1 – By-Pass Bit 2 – Shorted SCR Bit 3 – Reverse 1.07

Opal Pro to Mod TCP Page 13 12.01 Input Word 27 Analog Output 16 = Current Reference 17 = Current Feedback 18 = Overload level 19 = Phase Angle 13.0

Opal Pro to Mod TCP Page 14 NOTE: The Opal Pro must have firmware version 1.70 or higher.

Opal Pro to Mod TCP Page 2

Opal Pro to Mod TCP Page 3 FOR YOUR SAFETY Only qualified personnel should install this equipment, after first reading and understanding a

Opal Pro to Mod TCP Page 4

Opal Pro to Mod TCP Page 5 Table of Contents INTRODUCTION ...

Opal Pro to Mod TCP Page 6 Opal Pro to Mod TCP Introduction The Opal Pro can be monitored and controlled over an Ethernet communication network using

Opal Pro to Mod TCP Page 7 LED Indicators Two bi-colour (red/green) LED indicators are mounted beside the network connector. The upper LED indicates

Opal Pro to Mod TCP Page 8 Opal Pro Parameter Settings The parameters in the Opal Pro used to configure the Ehernet interface card (group 14) are onl

Opal Pro to Mod TCP Page 9 15.04 Comm Fault Enable Disable Enable – Opal Pro trips out on a communication fault Disable – Nothing happens on a commu